04-06-2016, 06:33 PM
(This post was last modified: 04-06-2016, 06:34 PM by pug306driver.)
Whilst working under the car today, 306 ph3 2l hdi, I noticed that the joint between the front pipe and cat, and the centre section has a crack, on the front pipe, and has been leaking. Been to the Klarius on line catalogue and seen that the front pipe has the taper joint, and a short stub which fits into the centre section, which is why the joint has not broken completely probably.
Do Klarius or other makers do a non cat straight thru front pipe as a direct replacement??
The rear section was replaced xmas time with a klarius, the centre section was newish when we got the car and is ok, again a Klarius, and i suspect that the front cat section may turn out to be a klarius also.
Do Klarius or other makers do a non cat straight thru front pipe as a direct replacement??
The rear section was replaced xmas time with a klarius, the centre section was newish when we got the car and is ok, again a Klarius, and i suspect that the front cat section may turn out to be a klarius also.