Also, not sure how well you'll understand this, but you can pre-load the actuator, and set a stop on VNT lever. This means a certain boost will need to be acheived before it will even move.
IE, you will need to stretch the actuator onto the lever, this way your actuator wont move linearly with boost, it will only move when e.g. 6 psi is acheived.
But doing this you will also have to make a stop from the VNT lever, otherwise the actuator will try to close the vanes right back up. This means no boost controller needed either!
IE, you will need to stretch the actuator onto the lever, this way your actuator wont move linearly with boost, it will only move when e.g. 6 psi is acheived.
But doing this you will also have to make a stop from the VNT lever, otherwise the actuator will try to close the vanes right back up. This means no boost controller needed either!
![[Image: 22f2b6b2-758b-4c1c-96fb-6fa9c6059b13_zpsf306b56b.jpg]](http://i585.photobucket.com/albums/ss299/Ha11elujaz0rs/22f2b6b2-758b-4c1c-96fb-6fa9c6059b13_zpsf306b56b.jpg)