11-04-2015, 01:47 PM
Hey everyone
I am going to fit a boost gauge when the inter cooler all goes in but I was wondering where people are running them from?
Some people tap into the wastegate pipe but I am thinking drill and tap the intake elbow and my mate has suggested that as well.
Surely both will show different pressures if there is pressure drop over the length of the pipe.
What pressures would I be aiming for on say a stage 2 map with the take off point at the elbow?
Thanks, Jack
I am going to fit a boost gauge when the inter cooler all goes in but I was wondering where people are running them from?
Some people tap into the wastegate pipe but I am thinking drill and tap the intake elbow and my mate has suggested that as well.
Surely both will show different pressures if there is pressure drop over the length of the pipe.
What pressures would I be aiming for on say a stage 2 map with the take off point at the elbow?
Thanks, Jack
