This is very important information for anybody thinking of doing a headgasket on the hdi engine, particularly if using Haynes as a guide:
Haynes specifies the 3-stage tightening for the headbolts as follows - 20nm, 60nm, 270*. The last figure SHOULD be 2 x 110*, NOT 270*. The other two figures are correct.
Could a mod sticky this please.
Haynes specifies the 3-stage tightening for the headbolts as follows - 20nm, 60nm, 270*. The last figure SHOULD be 2 x 110*, NOT 270*. The other two figures are correct.
Could a mod sticky this please.