306oc - Peugeot 306 Owners Club & Forum › Engines › XUD Section v
Cylinder head mani stud hole thread spacing

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Cylinder head mani stud hole thread spacing
Ruan Offline
"Gearbox Side" towards engine 4 lyf

Registered users - Donated
Posts: 5,205
Threads: 91
Joined: Dec 2011
Reputation: 83
Location: Oxfordshire/Cornwall
Car Model/Spec: Moonstone DT/Volvo V50
Thanks: 2
Given 41 thank(s) in 41 post(s)
#4
02-04-2014, 11:21 AM
Did I????

I would have said don't use bolts as it weighs a lot doing them up and you'll f*ck the threads... I'd never say extend them... You're likely to punch through an oil or water way..
(16-05-2016, 10:45 AM)Toms306 Wrote: Oh I don't care about the stripped threads lol, that's easily solved by hammering the bolt in. Wink
Nanstone GTD5 GT17S - XUD9TE
Volvo V50 D5 R-Design SE Sport - Daily cruise wagon.
Find
Reply
Thanks given by:


Messages In This Thread
RE: Cylinder head mani stud hole thread spacing - by Ruan - 02-04-2014, 11:21 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Cylinder head manni surface sanding 306Puggy 9 3,079 05-08-2020, 03:11 PM
Last Post: ekjdm14
  the more robust engine cylinder head niciou 4 1,688 03-07-2016, 12:52 PM
Last Post: Dave
  ARP head stud xud9ate niciou 9 2,287 14-04-2016, 03:09 PM
Last Post: Gitshdtub

Forum Jump:


Users browsing this thread: 1 Guest(s)