Garrett GT20 Project

[Dave]

Looking good, for that sort of stuff, you can always make your holes slightly bigger so you have abit of tolerance incase your hole spacing isn't entirely accurate (which it wont be if your using from cardboard templates). I might have missed this in the thread previously, but what are you going to do about the actutor and clocking the compressor?, 'cos this is gonna be a major issue even for someone with a welder, a bracket will need to be made, and fitted so it doesnt foul, and where your actuator will then sit, is exactly where your turbo outlet for your intercooler is. You could possibly bend the actuator rod and have it behind the compressor which would work, and then get someone to just simply tack it in place on something steel, this would be the option I would go for.