306oc - Peugeot 306 Owners Club & Forum › Engines › XUD Section v
MBC fitting

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
MBC fitting
londondan86 Offline
Living for the 306
Posts: 1,833
Threads: 91
Joined: Dec 2011
Reputation: 12
Location: Wrexham
Car Model/Spec: 306 D Turbo
Thanks: 0
Given 0 thank(s) in 0 post(s)
#4
28-06-2012, 07:20 PM
Is it a metal pipe on the k14? On a T2 it is a rubber hose which goes from the compressor housing to the actuator, cut this, fit mbc. Done! But make sure you install it the correct way, the arrow on the mbc will point to the actuator iirc.
Supercharged XUD Project - Dead

HDi Cabby Project Click
Find
Reply
Thanks given by:


Messages In This Thread
MBC fitting - by Jackabeen - 28-06-2012, 07:14 PM
RE: MBC fitting - by 4WayDiablo - 28-06-2012, 07:16 PM
RE: MBC fitting - by strictly_perv - 28-06-2012, 07:19 PM
RE: MBC fitting - by londondan86 - 28-06-2012, 07:20 PM
RE: MBC fitting - by Jackabeen - 28-06-2012, 08:04 PM
RE: MBC fitting - by mark_airey - 29-06-2012, 07:13 AM
RE: MBC fitting - by Jackabeen - 30-06-2012, 10:49 AM
RE: MBC fitting - by Jenkosowls - 30-06-2012, 10:54 AM
Re: RE: MBC fitting - by mark_airey - 30-06-2012, 10:52 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)