06-06-2012, 05:20 PM
Nice one lads.
I didn't remove the rear light to make the mould, you want to mould round it so the box can slide in and out easily and I didn't want to have to chop anything original so just mask round that too. Bit annoyed though as I forgot to put the jack and brace back before moulding so doubt that will fit now.
Angles wise isn't that hard either. You just make a mould bigger than needed and cut down to suit and the angle on the corner was just done with a hacksaw and plenty of swearing after it was all built and then cut to suit.
I didn't remove the rear light to make the mould, you want to mould round it so the box can slide in and out easily and I didn't want to have to chop anything original so just mask round that too. Bit annoyed though as I forgot to put the jack and brace back before moulding so doubt that will fit now.
Angles wise isn't that hard either. You just make a mould bigger than needed and cut down to suit and the angle on the corner was just done with a hacksaw and plenty of swearing after it was all built and then cut to suit.