Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
MOT Feedback Brake Pipe and Ball Joint
#3
1 (both front and rear) Brake pipe slightly corroded

wire brush off paint or rub grease on the line to stop further corrosion

2 Offside front track rod end ball joint has slight play

replace before next mot

3 Nearside front Anti-roll bar linkage ball joint dust cover damaged, but preventing ingress of dirt

these are cheap so get it replaced when you do the TRE above

4 Small oil leak

investigate it clean the area work out where and how much its leaking them make a decision on urgency
Reply
Thanks given by:


Messages In This Thread
Re: MOT Feedback Brake Pipe and Ball Joint - by cully - 19-05-2012, 01:06 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Brake pipe failure Mighty306 3 2,038 15-08-2020, 03:27 PM
Last Post: ekjdm14
  Do I buy? rear brake pipe corroded, covered in grease or other material pipes Charlie0 3 8,619 18-04-2019, 10:14 AM
Last Post: Mighty306
  Plastic brake pipe clips Mighty306 3 2,502 12-04-2018, 01:25 PM
Last Post: Mighty306

Forum Jump:


Users browsing this thread: 2 Guest(s)