03-05-2012, 10:01 AM
As mentioned in my zx thread earlier, i'm trying to take the head off the pump to replace the seal. I've hit problems already and not really sure where to go with it. Any chance somebody could list what i have to do in order to remove the head of the pump..?
So far the lda pin is out and the head is unbolted, plus various other bits have been undone/disconnected to make it all more accessible. I realised i was stuck and went to put it back together, but think i've dislodged something as the head doesn't want to sit back down on the body of the pump nicely, and i don't want to force it.
99% sure i haven't disconnected anything i shouldn't, yet! Will go and take a picture in just a sec. Any and all input welcome, even if it comes attached to desultory (and probably deserved) comments lol.
So far the lda pin is out and the head is unbolted, plus various other bits have been undone/disconnected to make it all more accessible. I realised i was stuck and went to put it back together, but think i've dislodged something as the head doesn't want to sit back down on the body of the pump nicely, and i don't want to force it.
99% sure i haven't disconnected anything i shouldn't, yet! Will go and take a picture in just a sec. Any and all input welcome, even if it comes attached to desultory (and probably deserved) comments lol.