18-04-2012, 12:16 PM
Sounds like the same problem me and Jake had when trying to bleed his dturbo the other week.
Open the bleed points, remove the rad cap/expansion tank cap, then put your hand over the hole where the cap goes and blow down the little pipe that should be coming off the expansion tank. Blow hard a few times and the system should 'burble', take in some of the water and then you need to top it up again, then just repeat, blow, top up, blow, top up, until water starts coming out of both bleed points, then tighten them up!
Open the bleed points, remove the rad cap/expansion tank cap, then put your hand over the hole where the cap goes and blow down the little pipe that should be coming off the expansion tank. Blow hard a few times and the system should 'burble', take in some of the water and then you need to top it up again, then just repeat, blow, top up, blow, top up, until water starts coming out of both bleed points, then tighten them up!
