XUD9 head bolt tightening sequence and torques

[mark_airey]

This is what I had :

Order-

8. 4. 1. 5. 9
7. 3. 2. 6. 10


Torque-

Stage one- 20Nm/15lbf ft

Stage two- 60Nm/44lbf ft

Stage three- Tighten 180 degrees

That's pretty much what Ruan said ^^ but as Ruan said, last stage should be 220* (and a bit, just make sure they are all the same)

And again, it doesn't really matter on the specific order of tightening as long as you start in the middle and sprial out as both Ruans and Dans second one do