13-09-2018, 02:07 PM
(This post was last modified: 13-09-2018, 02:50 PM by Rippthrough.)
I'm making a small batch of these for the 406 guys, 70mm mounts with a small dead zone like OE bushes have to reduce the idle vibration's usually suffered with poly mounts in a HDi (Can be used for petrol XU's too!), similar to this one:
They're a single piece design, avoiding the splitting issues encountered with some other 2-piece poly inserts.
I'll have two spare mounts from the batch, if anyone wants one - £45 each
If you get in touch with me before they're finished I can tailor the stiffness to your liking/usage, otherwise they'll be roughly equivilent to 70A shore poly bushes, although very progressive (I.E, it goes from the ~50A to 90A depending on how much torque you put through it) compared to something like a powerflex.
They're a single piece design, avoiding the splitting issues encountered with some other 2-piece poly inserts.
I'll have two spare mounts from the batch, if anyone wants one - £45 each
If you get in touch with me before they're finished I can tailor the stiffness to your liking/usage, otherwise they'll be roughly equivilent to 70A shore poly bushes, although very progressive (I.E, it goes from the ~50A to 90A depending on how much torque you put through it) compared to something like a powerflex.
Custom roll cages/shiny suspension bits/general fabrication work undertaken, PM me.
Top engine mount repair/reinforcement/chocking for cracked chassis and high powered cars, drive in, drive out, 2 hour turnaround.
Top engine mount repair/reinforcement/chocking for cracked chassis and high powered cars, drive in, drive out, 2 hour turnaround.