06-04-2018, 02:12 PM
Open bleed on thermostat housing and where heater hoses enter bulkhead. Also open bleed in top of rad if you have one. Close each as coolant starts to p*ss out. The highest is the heater hose bleed and so will be the last you should close.
Haynes then recommend you run the vehicle until hot with the header funnel still fixed in place, and leave it in place until the car has cooled again.
When warming the car up turn the interior heater to full and make sure the air coming through is properly warm. That way you know that part of the system has filled properly.
Suggest you try all this with a thermostat fitted in the cooling system.
Haynes then recommend you run the vehicle until hot with the header funnel still fixed in place, and leave it in place until the car has cooled again.
When warming the car up turn the interior heater to full and make sure the air coming through is properly warm. That way you know that part of the system has filled properly.
Suggest you try all this with a thermostat fitted in the cooling system.