30-01-2018, 09:35 PM
(30-01-2018, 07:30 PM)Blandy Wrote: What else have you done to fit the cams? Intrigued as have a set of 110’s at home planned for my engine
Id heard of people having pistons machined but that sounded too close for comfort so i brought the wossner high compression piston set and had my conrod small ends machined to accept a bush. Other than that nowt. Not sure on the spec of your cams but i think i get 2mm lift on the inlet at tdc and 1.4mm exhaust. I checked my clearances and had plenty. Get them in!