Bucket Seat

[TommiePuglet]

Depends how good your welding is! Lots of people do because its cheaper or they can mount them lower than any off the shelf mounts can.

I did some in my first car and all i did was make up to solid metal runners that married to the bolting holes bolted them in place sat the seat ontop where i liked it drilled and bolted the holes using a guide and that was fine even survived the car rolling 6 times

Tried and tested then. Crack on! Not sure if the seats need to adjust for MOT?

I will store the original for that moment I think much like the steering wheel gets put back when its time for an M.O.T