08-03-2017, 07:48 PM
cut outer tubular shaft in half, fit both parts.
lower vehicle to point where shafts will be fully compressed, due to inclination of the strut I believe this is near fully compressed, so takeing the springs off or using a spare damper without a spring will be needed.
trim away bits of tube till both halves will meet with the inner joint fully compressed, then take off a little more to account for any lateral engine/gearbox movement.
make a plug that fits snugly in both halves, drill through the tube and puddle weld onto the plug, then seam the centre after veeing it out, sometimes two passes will be required
lower vehicle to point where shafts will be fully compressed, due to inclination of the strut I believe this is near fully compressed, so takeing the springs off or using a spare damper without a spring will be needed.
trim away bits of tube till both halves will meet with the inner joint fully compressed, then take off a little more to account for any lateral engine/gearbox movement.
make a plug that fits snugly in both halves, drill through the tube and puddle weld onto the plug, then seam the centre after veeing it out, sometimes two passes will be required
need a part number? http://public.servicebox.peugeot.com/ and http://service.citroen.com/ will sort you out.