19-09-2016, 04:00 PM
(This post was last modified: 19-09-2016, 04:05 PM by pug306driver.)
mmmmm, i have a strong joist to hang/block and tackle the engine from for lift, but would need to roll the car back so can lower the engine/g/box onto the deck to work on, its rolling down hill as well !!
dont have a fully covered work space so its not secure, only have a car port to work under.
I have a "beam" to support engine and then remove g/box, but would like engine out for egr blanking,manifold cleaning etc..
same problem if i get a machine mart crane!! limited covered space at front of car and roll the crane with engine/g/box up hill !!! thats gunna be fun.
will visit scrappy and do some more research.
what is the internal diameter of the bearings so can make up a home made bearing holder together er, with tube, long bolt and end washer/nut. I have a lathe.
bearing numbers??
visit scrappy is the thing to do, get 2 knackered cv joints, easier all round.
dont have a fully covered work space so its not secure, only have a car port to work under.
I have a "beam" to support engine and then remove g/box, but would like engine out for egr blanking,manifold cleaning etc..
same problem if i get a machine mart crane!! limited covered space at front of car and roll the crane with engine/g/box up hill !!! thats gunna be fun.
will visit scrappy and do some more research.
what is the internal diameter of the bearings so can make up a home made bearing holder together er, with tube, long bolt and end washer/nut. I have a lathe.
bearing numbers??
visit scrappy is the thing to do, get 2 knackered cv joints, easier all round.