25-04-2016, 04:40 PM
Ok...
So just in case someone else has sorted this or I manage to...
Ph2 loom is same as ph1... As i thought tbh.
Basically xud9 loom has 1 big chassis leg plug and one small one.
Dw8 engine loom has only one small plug.
Rpm sensor runs through the BIG xud9 loom plug...but no receiving end exists on this estate on the chassis leg.
Anyone have any ideas!?
(other than what i am trying to avoid but planning which is a lot of wiring splicing n bodgin)
So just in case someone else has sorted this or I manage to...
Ph2 loom is same as ph1... As i thought tbh.
Basically xud9 loom has 1 big chassis leg plug and one small one.
Dw8 engine loom has only one small plug.
Rpm sensor runs through the BIG xud9 loom plug...but no receiving end exists on this estate on the chassis leg.
Anyone have any ideas!?
(other than what i am trying to avoid but planning which is a lot of wiring splicing n bodgin)
Wishes for more power...