Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
XUD into a dw8....wiring, rpm
#5
(20-04-2016, 07:36 AM)welshpug Wrote: what timing tooth does the dw8 use?  probably that is different or not connected

It is different, hence you need to use the ph2 XUD9 clocks for it to work. Sensor is also different, but when the looms are changed for a Ph2 DT, you get the right plug, uses same wires, but signal is diff.

There's multiple different types of Ph1 loom from memory, hence you can never be sure...
(16-05-2016, 10:45 AM)Toms306 Wrote: Oh I don't care about the stripped threads lol, that's easily solved by hammering the bolt in. Wink
Nanstone GTD5 GT17S - XUD9TE
Volvo V50 D5 R-Design SE Sport - Daily cruise wagon.
Reply
Thanks given by:


Messages In This Thread
XUD into a dw8....wiring, rpm - by Piggy - 20-04-2016, 06:29 AM
RE: XUD into a dw8....wiring, rpm - by Ruan - 20-04-2016, 07:18 AM
RE: XUD into a dw8....wiring, rpm - by welshpug - 20-04-2016, 07:36 AM
RE: XUD into a dw8....wiring, rpm - by Piggy - 20-04-2016, 07:37 AM
RE: XUD into a dw8....wiring, rpm - by Ruan - 20-04-2016, 07:45 AM
RE: XUD into a dw8....wiring, rpm - by welshpug - 20-04-2016, 07:55 AM
RE: XUD into a dw8....wiring, rpm - by Ruan - 20-04-2016, 08:56 AM
RE: XUD into a dw8....wiring, rpm - by Piggy - 25-04-2016, 04:40 PM
RE: XUD into a dw8....wiring, rpm - by cully - 25-04-2016, 04:48 PM
RE: XUD into a dw8....wiring, rpm - by Piggy - 25-04-2016, 06:32 PM
RE: XUD into a dw8....wiring, rpm - by Piggy - 29-04-2016, 05:28 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)