19-02-2016, 06:54 PM
Right ive done the coils and out her on a ramp to get at the cat which should arrive friday, after reading the guides etc it seems a very doable job, if too tough then ill dtive to a garage and fit it but ill give it a go first. Couple of things though if anyone could help me out?
With the lamda sensor removal from the old cat ready to put on the new one- will it damage the lamda wire if i twist the 22mm nut at the cat end? It seems it might twist it and poss damage if i dont disconnect from the heat shield end first- which seems the longer way about it. Is this true?
Whats the best exhaust fitting kit to use to fit the cat- is a dealerships own version the best or is an ECP one ok? Thanks
With the lamda sensor removal from the old cat ready to put on the new one- will it damage the lamda wire if i twist the 22mm nut at the cat end? It seems it might twist it and poss damage if i dont disconnect from the heat shield end first- which seems the longer way about it. Is this true?
Whats the best exhaust fitting kit to use to fit the cat- is a dealerships own version the best or is an ECP one ok? Thanks