09-01-2016, 10:52 AM
Phase 1 headlamps are WAY easier to mask than later ones. The headlamp glass just comes off by removing the metal clips around it, and the "black" part is just a piece of plastic which is held on by a couple of small bolts. You simply undo them and paint/wrap the plastic your desired colour.
Have a look at this post in my project thread:
http://306oc.co.uk/forum/showthread.php?...#pid471035
They were originally reflective but the coating had long since flaked off, so I simply wrapped them in aluminium tape to get them looking shiny again. The glass is frosted so you can't see the surface that clearly through it. If you want them black, just get them out and paint them black and bang them back in. No need to buy any more parts or anything.
Hope that helps.
Have a look at this post in my project thread:
http://306oc.co.uk/forum/showthread.php?...#pid471035
They were originally reflective but the coating had long since flaked off, so I simply wrapped them in aluminium tape to get them looking shiny again. The glass is frosted so you can't see the surface that clearly through it. If you want them black, just get them out and paint them black and bang them back in. No need to buy any more parts or anything.
Hope that helps.
This post is an artistic work of fiction and falsehood. Only a fool would take anything posted above as fact.
62k Diablo Phase 1 Gti-6: Project Thread
62k Diablo Phase 1 Gti-6: Project Thread