Ph1 Hdi conversion cutting out

[aggyj17]

I'm working with him and has helped to put the engine in. The car is basically a ph3 now as it has the entire ph3 loom all plugged in no cutting and joining. The donor car was running absolutely fine on stage 2 power no cutting out or anything. Basically now the car will fire up and run for 5-20 seconds and then will start to advance itself quite alot (quite bad diesel knock) and then just cut out bringing up that error code.

---

Also the car runs at around 525 bar on idle then when it starts to knock the pressure starts to rise up to 850ish before cutting out.

---