Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Confirm a head hole for me.
#4
See I thought the oil drains were down the side. This would be two high pressure feeds I think. (had help with this) its an xud9 gasket on an xud 11. So I might mill an xud9 head out so one feed can feed both if that makes sense. If they are both high pressure.

Where my finger is is where the hole would be on an xud9 for reference. everything else lines up


Attached Files Image(s)
   
On a break from 306oc for personal reasons. If anyone needs or wants me most of you have my number and or facebook messenger
Thanks for the good times guys n gals. I might be back. Who knows.
Reply
Thanks given by:


Messages In This Thread
Confirm a head hole for me. - by bashbarnard - 17-12-2015, 12:44 PM
RE: Confirm a head hole for me. - by Toms306 - 17-12-2015, 12:50 PM
RE: Confirm a head hole for me. - by Jonny81191 - 17-12-2015, 01:21 PM
RE: Confirm a head hole for me. - by bashbarnard - 17-12-2015, 01:52 PM
RE: Confirm a head hole for me. - by Jonny81191 - 17-12-2015, 02:05 PM
RE: Confirm a head hole for me. - by bashbarnard - 18-12-2015, 06:46 AM
RE: Confirm a head hole for me. - by ozpug - 23-12-2015, 08:12 AM
RE: Confirm a head hole for me. - by Dave - 26-12-2015, 12:59 AM
RE: Confirm a head hole for me. - by ozpug - 27-12-2015, 07:48 AM
RE: Confirm a head hole for me. - by bashbarnard - 26-02-2016, 07:55 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Big rust hole :( daveylennon93 5 1,906 01-08-2014, 01:44 PM
Last Post: daveylennon93
  Cylinder head mani stud hole thread spacing 306Puggy 7 2,393 06-04-2014, 01:40 PM
Last Post: 306Puggy
  Cambelt Change (timing hole alignment) Mark 30 17,243 09-07-2013, 05:24 PM
Last Post: ADV_93

Forum Jump:


Users browsing this thread: 1 Guest(s)