16-12-2015, 06:29 PM
I am currently looking at replacing the fuel lines in the engine bay, from the fuel rail too the plastic fuel lines at the iner wing
i am looking at going to AN6 fittings welded to the fuel rail,
8mm braided lines,
do i use teflon or rubber tube ?
now im stuck at what to fit to the plastic lines
do the AN6 Barb fittings push into the plastic lines at the bulkhead after you remove the white/green plastic elbows?
i am looking at going to AN6 fittings welded to the fuel rail,
8mm braided lines,
do i use teflon or rubber tube ?
now im stuck at what to fit to the plastic lines
do the AN6 Barb fittings push into the plastic lines at the bulkhead after you remove the white/green plastic elbows?
https://www.check-mot.service.gov.uk/
GTI6 Info
Don’t drive faster than your guardian angel can fly.