306oc - Peugeot 306 Owners Club & Forum › Engines › XUD Section v
Car won't go near redline?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Car won't go near redline?
Mattcheese31 Offline
Part of a Bumming Club
Moderators
Posts: 6,367
Threads: 87
Joined: Dec 2011
Reputation: 48
Location: South Yorks.
Car Model/Spec: Rouge vallelunga 5 door Dturbo
Soundcloud YouTube
Thanks: 2
Given 74 thank(s) in 70 post(s)
#7
30-11-2015, 12:16 PM
(30-11-2015, 12:15 PM)andywhy Wrote: I was mainly talking at stock which is why I said "unless you've been tuning" Smile Otherwise there is little point going up that high.

yes but 3k isn't "high" is it? is stage 1 serious tuning lol . . .Smile
Phase 1 D-Turdo, K14@24 psi, De-cat, meaty backbox, Bosch pump, grinded LDA pin, duel air fed K&N =133.7bhp & 188ft/lbs
Find
Reply
Thanks given by:


Messages In This Thread
Car won't go near redline? - by WukaChop - 29-11-2015, 11:11 PM
RE: Car won't go near redline? - by WiNgNuTz - 29-11-2015, 11:48 PM
RE: Car won't go near redline? - by Dave - 30-11-2015, 12:36 AM
RE: Car won't go near redline? - by andywhy - 30-11-2015, 12:09 PM
RE: Car won't go near redline? - by Mattcheese31 - 30-11-2015, 12:14 PM
RE: Car won't go near redline? - by andywhy - 30-11-2015, 12:15 PM
RE: Car won't go near redline? - by Mattcheese31 - 30-11-2015, 12:16 PM
RE: Car won't go near redline? - by WiNgNuTz - 30-11-2015, 03:57 PM
RE: Car won't go near redline? - by Paul_13 - 30-11-2015, 06:46 PM
RE: Car won't go near redline? - by Danny Wideboy - 30-11-2015, 06:54 PM
RE: Car won't go near redline? - by Dave - 01-12-2015, 05:00 PM
RE: Car won't go near redline? - by Danny Wideboy - 01-12-2015, 05:58 PM
RE: Car won't go near redline? - by welshpug - 02-12-2015, 12:08 PM
RE: Car won't go near redline? - by Ruan - 02-12-2015, 01:47 PM
RE: Car won't go near redline? - by Paul_13 - 02-12-2015, 07:05 PM
RE: Car won't go near redline? - by DarkInferno - 07-12-2015, 01:34 AM
RE: Car won't go near redline? - by Mattcheese31 - 07-12-2015, 11:07 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)