09-11-2015, 09:43 PM
(This post was last modified: 09-11-2015, 09:45 PM by MartinCartman.)
(09-11-2015, 09:29 PM)eHDi--Power Wrote: The wastegate actuator needs to be set up correctly for the MBC to work. You ideally want the wastegate to open a few psi before your target pressure and then tap in the MBC and wind it up to your desired pressure, otherwise the wastegate will just creep open
I think , but original wastegate actuator is open in 0.5 Bar and i set maximal for 1,4 bar with MBC and original wastegate actuator blows all around and dont have more pressure than 1.4 bar with original wastegate ? :/ I need minimal pressure 1,8-2 bar to 180HP.
I do not know how to do it drove , in the Czech Republic never happens HDI
in the Czech Republic government building f*cking TDI ..... :/
I am building my HDI with using this forum even though I have RHZ .(09-11-2015, 09:37 PM)Ruan Wrote: Are you using the actuator of the Saab?? If so that's likely your problem, you need an actuator with a stiffer spring than the Saab one, since it's designed for very low pressure, the exhaust manifold pressure will blow the wastegate open.
Nice build though
Yes i using actuator of the saab , How else do I use ?
And Thx