04-08-2015, 02:38 PM
Mounts do not cause camber (excessive camber, they have some camber as standard)
how much camber is standard please, either degrees or measurement from the vertical?? I presume the camber is negative ( leans in at the top of the wheel/tyre ).
will check the mounts cos if the near side mounts have "collapsed", this might show a lean in at the top of the wheel/tyre on the n/side and make the o/s seem "vertical" ??
as said no banging or squeeking etc heard and the system does not seem to have any "play", a bit difficult to check for ( rock about ) due to torsion bars.....will make a "roller" from scaffold tube etc and check.
how much camber is standard please, either degrees or measurement from the vertical?? I presume the camber is negative ( leans in at the top of the wheel/tyre ).
will check the mounts cos if the near side mounts have "collapsed", this might show a lean in at the top of the wheel/tyre on the n/side and make the o/s seem "vertical" ??
as said no banging or squeeking etc heard and the system does not seem to have any "play", a bit difficult to check for ( rock about ) due to torsion bars.....will make a "roller" from scaffold tube etc and check.