Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Temp gauge raising
#6
As these have said 90 is too high under normal conditions, and it shouldn't go above 93 as the fans should kick in then to fetch it down, temps under nirmal running should be around 80, check the coolant is fresh, while the cap is off check the coolant is circulating, also check your heaters blow hot, if not coolant needs bleeding properly, check no leaks in cooling system, after that thermostat could be stuck closed or fins in rad missing or full of shit inside, the state of your coolant will let you know if it's crudded up or not, good luck Smile
Phase 1 D-Turdo, K14@24 psi, De-cat, meaty backbox, Bosch pump, grinded LDA pin, duel air fed K&N =133.7bhp & 188ft/lbs
Reply
Thanks given by:


Messages In This Thread
Temp gauge raising - by Danaidh - 04-05-2015, 01:03 PM
RE: Temp gauge raising - by Seb_Ryan - 04-05-2015, 01:09 PM
RE: Temp gauge raising - by Danaidh - 04-05-2015, 02:21 PM
RE: Temp gauge raising - by Piggy - 04-05-2015, 03:47 PM
RE: Temp gauge raising - by Seb_Ryan - 04-05-2015, 04:09 PM
RE: Temp gauge raising - by Mattcheese31 - 04-05-2015, 07:02 PM
RE: Temp gauge raising - by kee616 - 05-05-2015, 12:15 AM
RE: Temp gauge raising - by Danaidh - 05-05-2015, 08:42 AM
RE: Temp gauge raising - by Danaidh - 05-05-2015, 05:30 PM
RE: Temp gauge raising - by Mattcheese31 - 05-05-2015, 07:16 PM
RE: Temp gauge raising - by Danaidh - 05-05-2015, 11:22 PM
RE: Temp gauge raising - by Mattcheese31 - 06-05-2015, 12:17 AM
RE: Temp gauge raising - by Danaidh - 06-05-2015, 04:49 PM
RE: Temp gauge raising - by Piggy - 06-05-2015, 04:57 PM
RE: Temp gauge raising - by Mattcheese31 - 06-05-2015, 05:02 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
Question which sensor feeds the temp gauge? Mattcheese31 4 2,010 23-03-2016, 12:18 AM
Last Post: Mattcheese31
  Temp gauge don't work!! CJRODELL 2 1,570 12-01-2015, 09:43 PM
Last Post: CJRODELL
  Oil pressure and temp gauge fittings on block? HDIkyle 11 3,091 23-04-2014, 09:29 AM
Last Post: r3k1355

Forum Jump:


Users browsing this thread: 1 Guest(s)