03-05-2015, 08:54 PM
so got the ph1 heater controls and system in
I had it all working fine. Then it stopped. - the fan that is
Its very simple supply, 12v ignition, earth and a 12v lighting supply.
All those are still good.
The heater controls seem fine, very basic internally, just tracks, all fine, no burnouts etc
The fan runs if given 12v/earth.
The fan has 12v when ignition on, assuming thus its controlled on the earth side. (I'm no electrical expert!)
The resistor pack is brand new.
Any suggestions?
I had it all working fine. Then it stopped. - the fan that is
Its very simple supply, 12v ignition, earth and a 12v lighting supply.
All those are still good.
The heater controls seem fine, very basic internally, just tracks, all fine, no burnouts etc
The fan runs if given 12v/earth.
The fan has 12v when ignition on, assuming thus its controlled on the earth side. (I'm no electrical expert!)
The resistor pack is brand new.
Any suggestions?
Wishes for more power...