07-03-2015, 03:58 PM
Hey all, When I put in my EGR blank I basically just sort of bodged it in using liquid gasket stuff. I wanted to do a proper job of it today so I bought my self some proper gaskets for the inlet elbow and also got some gasket paper for the egr valve bit.
The problem is that I can't get the elbow off to actually put a new gasket on. I managed to loosen the rubber hose on the bottom, removed two 13mm nuts (lost one, managed to get a replacement) I removed the two egr hex pins from the back and then tried to pull it off. It wouldn't move far enough to the right to be able to get it to come off the bolts that stay in the intake manifold.
Any tips for getting this stupid thing off haha? It's driving me mad lol.
Also is the hose that comes off the inlet elbow and goes to the plastic pipe 51mm or 57mm ID?
Thanks, Jack
Thanks, Jack
The problem is that I can't get the elbow off to actually put a new gasket on. I managed to loosen the rubber hose on the bottom, removed two 13mm nuts (lost one, managed to get a replacement) I removed the two egr hex pins from the back and then tried to pull it off. It wouldn't move far enough to the right to be able to get it to come off the bolts that stay in the intake manifold.
Any tips for getting this stupid thing off haha? It's driving me mad lol.
Also is the hose that comes off the inlet elbow and goes to the plastic pipe 51mm or 57mm ID?
Thanks, Jack
Thanks, Jack
