|
Tap and Die Set
|
Posts: 72
Threads: 4 Joined: Dec 2014 Location: Kent Thanks: 0
Given 1 thank(s) in 1 post(s) Country: 
22-01-2015, 09:28 PM
(22-01-2015, 07:51 PM)Dum-Dum Wrote: I have a small sealey or clarke or similar set that cost about £15 and has M4-M12 taps and dies plus the holders and a thread pitch gauge. I've had it for 5+ years and never had an issue and the only stuff I've had to buy to add to it are a couple of BSP taps and M12x1.25 which is the peugeot wheel bolt thread as standard M12 is M12x1.5 Very handy too know as I have one wheel bolt thread that has pulled bit of thread |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Tap and Die Set - by silverzx - 22-01-2015, 12:44 PM
RE: Tap and Die Set - by Eeyore - 22-01-2015, 12:52 PM
RE: Tap and Die Set - by r3k1355 - 22-01-2015, 12:59 PM
RE: Tap and Die Set - by zx_volcane - 22-01-2015, 01:45 PM
RE: Tap and Die Set - by Poodle - 22-01-2015, 02:03 PM
RE: Tap and Die Set - by silverzx - 22-01-2015, 02:13 PM
RE: Tap and Die Set - by nominous - 22-01-2015, 02:40 PM
RE: Tap and Die Set - by Poodle - 22-01-2015, 06:11 PM
Tap and Die Set - by todd1983 - 22-01-2015, 07:09 PM
RE: Tap and Die Set - by Dum-Dum - 22-01-2015, 07:51 PM
RE: Tap and Die Set - by Dave - 22-01-2015, 08:32 PM
Tap and Die Set - by todd1983 - 22-01-2015, 09:28 PM
RE: Tap and Die Set - by nominous - 23-01-2015, 09:46 AM
RE: Tap and Die Set - by silverzx - 23-01-2015, 10:27 AM
|
