20-01-2015, 06:31 PM
I spoke to CG today and they have had a look at the pressure plate and have measured it with the standard 1 i sent them and he said there are no higher bits on it than the standard 1 so i dont have a clue what is going on. In some of the pics i took of the CG 1 next to a standard 1 it defo looked higher in certain places. This really does have me stumped.
Like the chap as CG there should be a reasonable about of clearance inside the gearbox for the clutch. I cant see there is anything wrong im doing and with a standard 1 its fine. I need to try the other clutch on the spare engine and see if thats ok but it should be as it was fitted before.
It just leaves me with an issue of a clutch i bought that is not a lot of good other than the friction plate i guess. I dunno if that would be any good to use with a standard pressure plate?
Like the chap as CG there should be a reasonable about of clearance inside the gearbox for the clutch. I cant see there is anything wrong im doing and with a standard 1 its fine. I need to try the other clutch on the spare engine and see if thats ok but it should be as it was fitted before.
It just leaves me with an issue of a clutch i bought that is not a lot of good other than the friction plate i guess. I dunno if that would be any good to use with a standard pressure plate?