205 Hdi

[andyyy]

My understanding of why it's on a 306 subframe etc is so as it will handle like a 306 rather than a 205. Personally I wouldn't of but it does kinda interest me to how it will handle when done. (assuming the subframe doesn't fall off when it goes round a corner or the steering rack) 



For the arches personally I'd do like my mate has done with his mini and make some completely custom one up put of sheet metal cut and rolled to suit welded on then filled to make smooth wouldnt Look bad if done right 
Similar to this - not his car but he's done nearly exactly the same 



Why has it even been put on chock block 


Theres flat blade connectors on that plug , female blade crimps could of been used and it would of taken half the time and not been a  fire hazard , and looked alright and no solder needed,  the other faults with the wiring have Been pointed out. 


Before you say I haven't read what you've said about it covering it up with tape and silicone is just another bodge 


And that weld has not penetrated and if you knew about welding a photo can tell slot,  if you had got enough heat into it 
1 it wouldn't look like pidgen sh*t 
2 I'm pretty sure it's would of melted atleast some of that underseal as it wasn't ground back very far 
3 it would of warped the panel if you ran the weld for that length 
4 you would of changed the colour of the steel around the weld it would of gone blueish from the heat 


I could go on but I doubt your going to listen 


I'm only saying how to do it because if you knew you wouldn't be doing things like how you are,  I strongly advise you listen to what everyone  has to say if not your only going to find out the hard way