(12-12-2014, 02:51 PM)tenwierdufos Wrote:(12-12-2014, 02:43 PM)procta Wrote: check the pipe going to the ecu to the inlet as that might causing bother.
Seems fine, connected both ends and not blocked, unless the sensor in the ecu itself is faulty.
I am trying to think of anything else that would make it act the goat. Only thing is the black box, also the sensor on the water elbow can make them run a bit odd too, as mine was acting up like hell!
change the sensors on the water elbow, with yours been a spi it may have one.
another sensor that can cause problems is the green sensor on the inlet, which is for the injection system.