10-12-2014, 08:34 PM
I'm trying to get the standard Ph3 Pug alarm to work on my car, and having a few problems.
The issue is when you lock it, the alarm goes off. Ultrasonics you might think, but I've pressed the button to isolate these from the system yet the alarm still goes off once locking via fob. Car is fine when locked with key, unlocks with fob OK too. Assuming the alarm uses the door shut sensors, I can rule these out as working because the interior light (front and rear) illuminates/goes out. Again, the tilt switch in the boot lid operates/turns off the boot light. Now, last of all is the bonnet shut sensor. I can't locate the typical alarm door shut sensor anywhere under the bonnet (behind the drivers headlight I understand?).
Can someone confirm the bonnet shut sensor on a Ph3 is behind the drivers headlight?
The issue is when you lock it, the alarm goes off. Ultrasonics you might think, but I've pressed the button to isolate these from the system yet the alarm still goes off once locking via fob. Car is fine when locked with key, unlocks with fob OK too. Assuming the alarm uses the door shut sensors, I can rule these out as working because the interior light (front and rear) illuminates/goes out. Again, the tilt switch in the boot lid operates/turns off the boot light. Now, last of all is the bonnet shut sensor. I can't locate the typical alarm door shut sensor anywhere under the bonnet (behind the drivers headlight I understand?).
Can someone confirm the bonnet shut sensor on a Ph3 is behind the drivers headlight?
2001 BMW 330Ci
2012 VW High Up
1988 205 GTi 1.6
1990 205 Mi16
2012 VW High Up
1988 205 GTi 1.6
1990 205 Mi16