09-12-2014, 11:45 PM
(This post was last modified: 09-12-2014, 11:48 PM by machsantos.)
(09-12-2014, 10:32 PM)Piggy Wrote: I can do some measurements for you but bear in mind that the engine may sit differently and be mounted at a different point on the engine to yours
Yeah well about that I keep asking myself about something: there is a picture on the thread I took where it shows the holes of right side of the bloc. Is there this very same holes (in same position) in the XUD9TE and XUD11?
(09-12-2014, 10:28 PM)Dum-Dum Wrote: I can't check engine height as i sold mine
Don't worry about the ECU, run it on a bosch fuel pump and you'll be fine. I put mine in a car that ran modern ECU high pressure direct injection and it was fine with that removed, just needed different clocks and a couple of alterations to the loom.
Edit: obviously I've never worked on a toyota so can't promise this.
Course but something keeps bodering me: my car uses a mass air flow meter while the XUD9TE and XUD11 (as far as I know) have only air temperature sensor. How will I manage this? I just put the same mass air flow meter on the admission of the XUD11 and hope the ECU makes no diference or just remove it and exchange it for a simple temperature sensor?
