306oc - Peugeot 306 Owners Club & Forum › Engines › XUD Section v
How To - 2.1TD Swap / XUD11 Fitting

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How To - 2.1TD Swap / XUD11 Fitting
Dum-Dum Offline
Lord of Unfinished Projects
Posts: 15,646
Threads: 541
Joined: Dec 2011
Reputation: 124
Location: Aylesbury
Car Model/Spec: 320bhp Impreza WRX
Thanks: 7
Given 59 thank(s) in 58 post(s)
#65
08-12-2014, 02:27 PM
38mm isnt alot of clearance above the engine as the 2.1 inlet is big and runs over the engine. It might fit but only just

Width is the same and I reckon you could bolt your standard mountings to the XUD11 block
Find
Reply
Thanks given by:


Messages In This Thread
How To - 2.1TD Swap / XUD11 Fitting - by Dum-Dum - 03-12-2012, 10:14 PM
RE: How To - 2.1TD Swap / XUD11 Fitting - by Ben - 04-12-2012, 09:28 AM
RE: How To - 2.1TD Swap / XUD11 Fitting - by Ruan - 08-12-2012, 08:24 PM
RE: How To - 2.1TD Swap / XUD11 Fitting - by Orta - 20-06-2014, 09:34 PM
RE: How To - 2.1TD Swap / XUD11 Fitting - by Dum-Dum - 08-12-2014, 02:27 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  lower height pistons xud11 of 1 mm niciou 3 5,461 01-03-2018, 07:44 PM
Last Post: niciou
Wink The judge and its xud11 Sambo the bodger 37 16,004 24-06-2017, 06:04 AM
Last Post: bashbarnard
  Turbo relocation xud11 and 1.4 hdi bits Sambo the bodger 7 5,258 04-02-2017, 08:24 AM
Last Post: Dum-Dum

Forum Jump:


Users browsing this thread: 4 Guest(s)