03-12-2014, 04:34 PM
(03-12-2014, 10:24 AM)Ruan Wrote:(02-12-2014, 10:15 AM)Toms306 Wrote:(01-12-2014, 11:45 PM)Ruan Wrote: You mean you've never had an awkward to access jubilee clip?!
Nope... I find jubilees tend to put on in a way that they can come off again! How would the last person fit it otherwise lol? There are short and deep 7mm sockets for the small ratchet or screwdriver handle which have been good enough so far... And I've stripped a few complete 306s with this kit lol.
Before the car was made and it was put on in the factory!!!
Classic one for that is the water distribution block on all XU engines, they put the clips on in the most retarded position.
But yeah, I know I can pick up another socket for a few quid, but you haven't got anywhere to put it! I'd much rather full sets of each, but that's just me probably!
Good point lol. But if its so inaccessible that the small 7mm socket on ratchet or driver handle can't do it, I don't see that a spanner would.
I never really use the other sets I have now. I do wish there was a couple of 'man' tools in with the kit though. Pliers/side cutters/hammer/chisel/etc. But for sockets, spanners and bits I really haven't needed any extra since getting the 200pc kit.
