Forged con rods in XUD.

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Forged con rods in XUD.

205 Mardi gras Offline

Offline

I'm new, be nice

Posts: 28
Threads: 3
Joined: Oct 2014

Thanks: 2
Given 1 thank(s) in 1 post(s)

#10

30-11-2014, 08:16 PM

There needs to be a bit of room for oil between the bush and pin and I'd rather they fitted like the original XUD rods did if I'm honest. I'll get them checked out properly this week. I don't want anything to seize up once it expands with heat. ...Luke.

Find

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Forged con rods in XUD. - by 205 Mardi gras - 27-11-2014, 05:10 PM

Forged con rods in XUD. - by Sambarker - 27-11-2014, 05:20 PM

RE: Forged con rods in XUD. - by 205 Mardi gras - 28-11-2014, 05:21 PM

RE: Forged con rods in XUD. - by zx_volcane - 28-11-2014, 07:18 PM

Forged con rods in XUD. - by Sambarker - 29-11-2014, 11:32 AM

RE: Forged con rods in XUD. - by 205 Mardi gras - 29-11-2014, 10:26 PM

Forged con rods in XUD. - by Sambarker - 30-11-2014, 07:24 AM

RE: Forged con rods in XUD. - by 205 Mardi gras - 30-11-2014, 06:08 PM

RE: Forged con rods in XUD. - by zx_volcane - 30-11-2014, 06:26 PM

RE: Forged con rods in XUD. - by 205 Mardi gras - 30-11-2014, 08:16 PM

Forged con rods in XUD. - by zx_volcane - 30-11-2014, 08:29 PM

RE: Forged con rods in XUD. - by 205 Mardi gras - 01-12-2014, 07:33 PM

RE: Forged con rods in XUD. - by nominous - 02-12-2014, 11:04 AM

RE: Forged con rods in XUD. - by 205 Mardi gras - 02-12-2014, 09:40 PM

RE: Forged con rods in XUD. - by Piggy - 02-12-2014, 10:17 PM

RE: Forged con rods in XUD. - by 205 Mardi gras - 05-12-2014, 08:11 PM

RE: Forged con rods in XUD. - by nominous - 03-12-2014, 09:51 AM

RE: Forged con rods in XUD. - by silverzx - 03-12-2014, 09:54 AM

RE: Forged con rods in XUD. - by zx_volcane - 03-12-2014, 10:50 AM

RE: Forged con rods in XUD. - by nominous - 03-12-2014, 11:03 AM

RE: Forged con rods in XUD. - by zx_volcane - 03-12-2014, 11:35 AM

RE: Forged con rods in XUD. - by nominous - 03-12-2014, 12:05 PM

Users browsing this thread: 1 Guest(s)