Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Removing Crank & Pistons
#1
Finally got round to stripping the old block last night then got stuck as the light started to fail.
The crank seems to just just not want to come out, it is completely free on the flywheel end and the oil seal is out at the pulley end. It seems like it is catching on the counterweights?? Any tips? Possibly pistons put first but then came up against the below issue!
Also the pistons don't want to come out of the bores, never known them to be this stiff before, on other engines it's usually just a case of knocking them through but these don't seem like they're going anywhere Sad Again, any tips. Maybe just a case of man up and hit harder but don't want to damage any!

[attachment=20283]
Supercharged XUD Project - Dead

HDi Cabby Project Click
Reply
Thanks given by:


Messages In This Thread
Removing Crank & Pistons - by londondan86 - 25-11-2014, 01:58 PM
RE: Removing Crank & Pistons - by 306Dan - 25-11-2014, 06:05 PM
RE: Removing Crank & Pistons - by welshpug - 25-11-2014, 06:16 PM
RE: Removing Crank & Pistons - by londondan86 - 25-11-2014, 07:34 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  lower height pistons xud11 of 1 mm niciou 3 5,936 01-03-2018, 07:44 PM
Last Post: niciou
  Forged pistons David 12 4,952 21-11-2014, 07:26 PM
Last Post: Ruan

Forum Jump:


Users browsing this thread: 1 Guest(s)