Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
pas removal
#6
Ok cool. You should be able to get it on and off ok if you release the idler, it should be quite tight though. Ideally you want to change the idler for something you can apply some proper tension with, just needs a square drive slot or something.
306 HDi Deathtrap - 130bhp / 220lbft
...UPGRADING...



Reply
Thanks given by:


Messages In This Thread
pas removal - by dr_jekyll - 18-11-2014, 09:13 AM
RE: pas removal - by Poodle - 18-11-2014, 09:50 AM
RE: pas removal - by dr_jekyll - 18-11-2014, 09:53 AM
RE: pas removal - by Poodle - 18-11-2014, 10:27 AM
RE: pas removal - by dr_jekyll - 18-11-2014, 10:30 AM
RE: pas removal - by Poodle - 18-11-2014, 10:33 AM
RE: pas removal - by dr_jekyll - 18-11-2014, 10:39 AM
RE: pas removal - by Toms306 - 18-11-2014, 10:39 AM
RE: pas removal - by dr_jekyll - 18-11-2014, 10:43 AM
RE: pas removal - by procta - 18-11-2014, 11:40 AM
RE: pas removal - by dr_jekyll - 18-11-2014, 11:57 AM
RE: pas removal - by powerandtorque - 18-11-2014, 12:57 PM
RE: pas removal - by dr_jekyll - 18-11-2014, 01:44 PM
RE: pas removal - by pug306driver - 18-11-2014, 04:15 PM
RE: pas removal - by Toms306 - 18-11-2014, 04:34 PM
RE: pas removal - by pug306driver - 18-11-2014, 04:54 PM
RE: pas removal - by Toms306 - 18-11-2014, 05:07 PM
RE: pas removal - by pug306driver - 18-11-2014, 05:14 PM
RE: pas removal - by Poodle - 18-11-2014, 07:20 PM
RE: pas removal - by dr_jekyll - 18-11-2014, 08:00 PM
RE: pas removal - by powerandtorque - 19-11-2014, 10:30 AM
RE: pas removal - by Uberderv - 18-11-2014, 11:24 PM
RE: pas removal - by dr_jekyll - 19-11-2014, 08:26 AM
RE: pas removal - by pug306driver - 19-11-2014, 10:06 AM
RE: pas removal - by dr_jekyll - 19-11-2014, 01:23 PM
RE: pas removal - by welshpug - 19-11-2014, 01:41 PM
RE: pas removal - by dr_jekyll - 19-11-2014, 06:20 PM
RE: pas removal - by Poodle - 20-11-2014, 06:42 AM
RE: pas removal - by pug306driver - 20-11-2014, 11:01 AM
RE: pas removal - by Poodle - 20-11-2014, 05:40 PM

Forum Jump:


Users browsing this thread: 4 Guest(s)