Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Hey guys I'm new here. Vnt question
#10
if you want to go for a vnt, you could slap a gt2052v on, control it via boost actuator and mbc - and utilise its full potential in the future with fuel upgrades, uprated head studs and a stronger bottom end.

It'd be overkill for the current setup, but would give you more flexibility in the future - and tbh it sounds like you just want to get involved and weld something on.

Picture wise there might not be anything specific, you'll just want to make some steel adaptor plates up so you can bolt the new turbo to the existing exhaust manifold and another for the downpipe.

Or as Ruan suggests, go for a gt15 or k03 off the later xud and have a cheap bolt on turbo that will be more responsive than the older T2 or K14.
Reply
Thanks given by:


Messages In This Thread
RE: Hey guys I'm new here. Vnt question - by Ruan - 15-11-2014, 11:54 AM
Hey guys I'm new here. Vnt question - by Frosty - 16-11-2014, 11:03 AM
RE: Hey guys I'm new here. Vnt question - by Ruan - 16-11-2014, 12:29 PM
RE: Hey guys I'm new here. Vnt question - by Ruan - 16-11-2014, 12:33 PM
RE: Hey guys I'm new here. Vnt question - by zx_volcane - 16-11-2014, 12:30 PM
RE: Hey guys I'm new here. Vnt question - by Ruan - 16-11-2014, 12:59 PM
RE: Hey guys I'm new here. Vnt question - by Ruan - 17-11-2014, 12:43 AM
RE: Hey guys I'm new here. Vnt question - by Ruan - 17-11-2014, 10:27 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)