05-11-2014, 09:36 AM
(04-11-2014, 10:06 PM)Piggy Wrote: Try just stamping on the pedal and few times then slip ya foot of the clutch and let it pop up
I'm not sure where this idea came from, all it does is damage the pedal stop at the top so its sits higher than it should.
Just driving on it or a couple of hard stamps without the destructive slip off should have the same effect.(05-11-2014, 07:24 AM)rocker8742 Wrote: When I fitted my new cable I managed to fit it the opposite of how you have so the pedal was always on the floor, I hadn't got the auto adjuster setup correctly.
Think it's maybe something similar ?
Did you open the adjuster mech before fitting the box end? But thats doable imo, it doesn't take any effort to keep the pedal on the floor. But with the OP's problem, it takes a lot of effort to push the clutch arm by hand. I just don't see how anyone could fit the cable with enough effort to disengage the clutch permanently.