13-10-2014, 10:53 PM
Hi zx volcane, assume you are Tom, I'm Aaron was talking to you about the rods last week!
Plans enginewise are to put my tig skills to the test and fab up some manifolds of the exhaust and inlet variation.
I have stripped and rebuilt a fair few engine so will hopefully get my hands on an xud9 to strip and rebuild with all the fancy bits. At the minute I'm trying to prep it for mot as I do plan to daily it whilst putting together a decent dturbine.
The brakes are adaquate because it's absolutely dead as hector and wouldn't pull the skin off a custard, but i wouldn't say they inspire confidence lol. They will hopefully be changed along with a gti subframe and 309 bottom arm set up to replace the sh1te arb control arm setup.
All of this is money and time permitting I have a lot of service work, welding and other projects to be at besides the main issue which is dough :/
Plans enginewise are to put my tig skills to the test and fab up some manifolds of the exhaust and inlet variation.
I have stripped and rebuilt a fair few engine so will hopefully get my hands on an xud9 to strip and rebuild with all the fancy bits. At the minute I'm trying to prep it for mot as I do plan to daily it whilst putting together a decent dturbine.
The brakes are adaquate because it's absolutely dead as hector and wouldn't pull the skin off a custard, but i wouldn't say they inspire confidence lol. They will hopefully be changed along with a gti subframe and 309 bottom arm set up to replace the sh1te arb control arm setup.
All of this is money and time permitting I have a lot of service work, welding and other projects to be at besides the main issue which is dough :/