12-10-2014, 07:42 PM
Yeah you want just the engine loom.
Also need to swap the filler neck (or remove the restrictor) and swap pump pick ups inside the tank to xud pickup. Also thus need to remove all the petrol lines and replace with XUD ones (may some carbon canister crap to remove too)
Swap the clocks to ph1 dt clocks. Think you may need to run the speedo cable through though...not sure if the ph1 xsi is cable or sensor run.
Shouldnt have any issues with subframe but I ran into a problem with the gear linkage mount was an inch further back on mine...but I converted a ph3
Also need to swap the filler neck (or remove the restrictor) and swap pump pick ups inside the tank to xud pickup. Also thus need to remove all the petrol lines and replace with XUD ones (may some carbon canister crap to remove too)
Swap the clocks to ph1 dt clocks. Think you may need to run the speedo cable through though...not sure if the ph1 xsi is cable or sensor run.
Shouldnt have any issues with subframe but I ran into a problem with the gear linkage mount was an inch further back on mine...but I converted a ph3
Wishes for more power...