03-10-2014, 08:44 AM
Just to add to the above take apart the front calipers grease the sliders (not copper grease) under the dust covers and pump them in and out a bit to make sure they slide well.
Re copper crease the pads so they can move freely then push the piston back in and pump it out (not too far) a few times to make sure its free.
Would take less than an hour a side.
Re copper crease the pads so they can move freely then push the piston back in and pump it out (not too far) a few times to make sure its free.
Would take less than an hour a side.