25-08-2014, 09:38 PM
(This post was last modified: 25-08-2014, 09:41 PM by daveylennon93.)
Yeah as bash said t2 is the only direct fitment. Much of a muchness between the 2, t2 prob a bit better.
As for front mount you can route all different ways.
I bought the one in the link a few weeks ago and got silicone pipes from autosiliconehoses as they were the cheepest and good quality.
Im goin to bring a 90* bend from the right of intercooler in past rad. And a 90* from left upwards and a 90* to bring it round the rad to face the pipe coming from
Turbo. Then pipe rest up with steel.
Also you can get an adaptor for the inlet manifold made up. I bought 1 off here in the parts section.
Heres link for fmic: http://m.ebay.ie/itm/251555444356?nav=SEARCH
What i bought from ash hoses: 2 90 degree 54mm bends
1 90 degree 51mm bend.
2 54 to 51mm reducers
And a 51mm coupler.
And 14 60-63mm T bolt hose clamps.
Hope thats helpful
Link for hoses: http://www.autosiliconehoses.com
As for front mount you can route all different ways.
I bought the one in the link a few weeks ago and got silicone pipes from autosiliconehoses as they were the cheepest and good quality.
Im goin to bring a 90* bend from the right of intercooler in past rad. And a 90* from left upwards and a 90* to bring it round the rad to face the pipe coming from
Turbo. Then pipe rest up with steel.
Also you can get an adaptor for the inlet manifold made up. I bought 1 off here in the parts section.
Heres link for fmic: http://m.ebay.ie/itm/251555444356?nav=SEARCH
What i bought from ash hoses: 2 90 degree 54mm bends
1 90 degree 51mm bend.
2 54 to 51mm reducers
And a 51mm coupler.
And 14 60-63mm T bolt hose clamps.
Hope thats helpful
Link for hoses: http://www.autosiliconehoses.com
HDI D'Turbo Daily Driver ---- XUD D'Turbo Project