Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
HDI rods and shells
#14
(06-07-2014, 07:05 PM)bashbarnard Wrote: At least your not running a dhy block. Im concerned everytime I get a bit carried away!

The fact your block is a dhy doesn't really make much difference. Once again its all luck of the draw. The fact is that the dhy is the most common block that these engines come with so the bigger percent of blocks that have chucked a rod prob have been a dhy but only cuz there the most common.

Well that my thoughts on it all any way
Reply
Thanks given by:


Messages In This Thread
HDI rods and shells - by pugmanxud - 06-07-2014, 04:59 PM
RE: HDI rods and shells - by zx_volcane - 06-07-2014, 05:12 PM
RE: HDI rods and shells - by pugmanxud - 06-07-2014, 05:23 PM
RE: HDI rods and shells - by toseland - 07-07-2014, 08:28 PM
RE: HDI rods and shells - by zx_volcane - 06-07-2014, 05:26 PM
RE: HDI rods and shells - by pugmanxud - 06-07-2014, 05:28 PM
HDI rods and shells - by Frosty - 06-07-2014, 05:34 PM
RE: HDI rods and shells - by Jimbo - 06-07-2014, 05:44 PM
RE: HDI rods and shells - by pugmanxud - 06-07-2014, 06:38 PM
RE: HDI rods and shells - by zx_volcane - 06-07-2014, 06:42 PM
RE: HDI rods and shells - by pugmanxud - 06-07-2014, 06:46 PM
RE: HDI rods and shells - by strictly_perv - 06-07-2014, 06:53 PM
RE: HDI rods and shells - by zx_volcane - 06-07-2014, 07:02 PM
RE: HDI rods and shells - by bashbarnard - 06-07-2014, 07:05 PM
RE: HDI rods and shells - by Frosty - 06-07-2014, 07:52 PM
Re: RE: HDI rods and shells - by bashbarnard - 06-07-2014, 07:53 PM
RE: HDI rods and shells - by mspdan - 07-07-2014, 09:25 AM
RE: HDI rods and shells - by pugmanxud - 07-07-2014, 08:52 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Wanted: Forged con rods/HDI shells,bearings Chris_90 4 1,530 11-03-2016, 10:08 PM
Last Post: Chris_90
  Hdi conrod shells Teddy 1 990 31-08-2014, 01:21 PM
Last Post: ash23
  morette outer shells and big brake kit Leemus 5 1,819 19-06-2013, 12:40 PM
Last Post: Leemus

Forum Jump:


Users browsing this thread: 1 Guest(s)