21-06-2014, 01:09 PM
(21-06-2014, 12:58 PM)Niall Wrote:
Right that is a 306 balljoint. The bit with the 3 holes sits inside the end of the wishbone. You want to measure from one of them bolt holes to the ball joint pin its self. I bet you will find that the one on the side your having troubles with is shorter than the other side. If so, replace the ball joint (only about £15 from ECP) with one for a PAS car.
Awesome thanks Niall so I wanna measure from the centre of the hole to the centre of the ball joint pin like this?
[attachment=17003]